Page 1 of 1

Need to upgrade to .11 from .10 -Many mods installed, advise

Posted: Wed Dec 08, 2004 2:57 am
by munkyxtc
I have a quite a few mods installed on my forums, and I do not want to have to go back through and manually update all of the files again, as it would be quite labor intensive. I downloaded the patch files to see exactly what was involved with using this method, and it states: "The patch file is probably the best solution for those with many Mods or other changes who do not want to re-add them back to all the changed files. To use this you will need command line access to a standard UNIX type patch application." Can someone point me in the right direction on this? I definately want to upgrade without having to reinstall a ton of mods.



Posted: Wed Dec 08, 2004 4:04 am
by munkyxtc
Can anyone assist with this?

Posted: Wed Dec 08, 2004 4:05 am
by iNfLuX
i'm in the same boat and could use some advice on this as well...

Posted: Wed Dec 08, 2004 4:23 am
by twister17e
Have you looked @ this?
Code Changes from .10 to .11 :P

Posted: Wed Dec 08, 2004 4:32 am
by iNfLuX
hmmm, no, but i've got 2.0.6 installed right now.. i've been searching but can't dig up much... one person noted to install the updated code by hand... how would i do this going from 2.0.6 to 2.0.11 and if i did it by hand and are replacing code, how can you prevent copying over cod that has been altered by a mod?

Posted: Wed Dec 08, 2004 4:34 am
by Drexion

Posted: Wed Dec 08, 2004 4:51 am
by iNfLuX
thanks a lot! but how do you know that you won't overwrite code that was altered by a mod? i don't remember the code changes done by mods on my forum and the vast majority of the mods did not insert notes indicating that such and such is mod'd code...

Posted: Wed Dec 08, 2004 4:53 am
by munkyxtc
Thanks! I'll give this a try, and post back with the results.


Posted: Wed Dec 08, 2004 5:42 am
by munkyxtc
I've just completed the installation from the suggestions offered above, and everything appears to be working flawlessly.

Thanks so much,