Page 1 of 1

First installation and set-up probs

Posted: Sat Mar 21, 2015 4:49 am
by sadulsepp
Hello.
I'm running old XMB forum for years.
Now decided to move onto phpBB platform.

we have very old andloyal customerbase. They can be difficult with changes. Therefore I'm trying to keep as much possible to look and feel same as the old forum was.

I have run into some difficulties so far.
If you look at the old forum (http://www.foorum69.org) than there are forums, subforums and topics.
I need to have same structure more-less in the new forum. All I have succeeded to generate on the forst page is nil. Only the same forum that was there as example and that's it.
Have not succeeded to create subforums or topics as visible in old forum.

I would appreciate if someone could point me to the page where the whole setup is explained or even better if someone could find 10-15 minutes to have a screencast with me and guide me through my misery to success.

With regards,
Sadulsepp

Re: First installation and set-up probs

Posted: Sat Mar 21, 2015 4:59 am
by Oyabun1
Information is available from:
Documentation
Knowledge Base
Flash tutorials
Development Wiki
Searching previous posts (many questions have been asked and answered before).

To make categories and forums
In Administration Control Panel (ACP) > FORUMS > Manage forums make a new forum.

Forum type: Category
Parent forum: No parent

Set permissions for category.

Then make another forum.
Forum type: Forum
Parent forum: the category you just made.

Set permissions for forum.

To set permissions, either use the option to copy permissions from an existing category or forum that has the desired permissions, or:
Administration Control Panel (ACP) > Permissions > Group forum permissions
Set the registered users to be able to see and post in it:
Registered users > Standard access

Re: First installation and set-up probs

Posted: Sat Mar 21, 2015 5:26 am
by Lumpy Burgertushie
from what I have seen , the easiest thing is to convert your xmb board to smf using a convertor found at smf site. then, convert smf to phpbb using the smf convertor found here.
you will need to install smf and put the smf tables in the same database as the xmb board is using.


roberrt