[CONVERT] Snitz (MsAccess) to phpBB

Converting from other board software? Good decision! Need help? Have a question about a convertor? Wish to offer a convertor package? Post here.
Ideas Centre
Locked
User avatar
MarcB
Registered User
Posts: 137
Joined: Sun Jun 14, 2009 2:48 pm
Location: Netherlands
Contact:

[CONVERT] Snitz (MsAccess) to phpBB

Post by MarcB » Thu Dec 26, 2013 8:05 pm

Dear All,

I have been busy trying to convert a Snitz version 3.4.06 MsAccess database into phpBB. Unfortunately so far without success.

The tool I found, snitz2phpbb2convertor-1.7 (see http://snitz2phpbb.sourceforge.net/), is able to convert a Snitz MySQL database into a phpBB MySQL database.

Because the Snitz forum is based on a MsAccess database I used the tool Bullzip Access to MySQL (see http://www.bullzip.com/products/a2m/info.php) to convert the Snitz MsAccess database to a MySQL database. The conversion did not show any errors.

Because the tool snitz2phpbb2convertor-1.7, works with phpBB2 2.0.19 I have installed phpBB2 2.0.19. Then I followed the instructions to run snitz2phpbb2convertor-1.7 but unfortunately it looks that the MySQL database is not updated.

Perhaps the method I try to apply is not correct and that there are much better ways to follow. Any advice how to proceed is very welcome!

Thanks in advance.

bilaluet
Registered User
Posts: 3
Joined: Wed Mar 04, 2015 9:05 am

Re: [CONVERT] Snitz (MsAccess) to phpBB

Post by bilaluet » Wed Mar 04, 2015 9:50 am

I have the exact same issue and need support.

User avatar
MarcB
Registered User
Posts: 137
Joined: Sun Jun 14, 2009 2:48 pm
Location: Netherlands
Contact:

Re: [CONVERT] Snitz (MsAccess) to phpBB

Post by MarcB » Fri Mar 06, 2015 4:31 pm

Unfortunately, I never got any feedback. Perhaps it is not possible.

Locked

Return to “[3.0.x] Convertors”