Page 1 of 1

[CONVERT] Snitz (MsAccess) to phpBB

Posted: Thu Dec 26, 2013 8:05 pm
by MarcB
Dear All,

I have been busy trying to convert a Snitz version 3.4.06 MsAccess database into phpBB. Unfortunately so far without success.

The tool I found, snitz2phpbb2convertor-1.7 (see, is able to convert a Snitz MySQL database into a phpBB MySQL database.

Because the Snitz forum is based on a MsAccess database I used the tool Bullzip Access to MySQL (see to convert the Snitz MsAccess database to a MySQL database. The conversion did not show any errors.

Because the tool snitz2phpbb2convertor-1.7, works with phpBB2 2.0.19 I have installed phpBB2 2.0.19. Then I followed the instructions to run snitz2phpbb2convertor-1.7 but unfortunately it looks that the MySQL database is not updated.

Perhaps the method I try to apply is not correct and that there are much better ways to follow. Any advice how to proceed is very welcome!

Thanks in advance.

Re: [CONVERT] Snitz (MsAccess) to phpBB

Posted: Wed Mar 04, 2015 9:50 am
by bilaluet
I have the exact same issue and need support.

Re: [CONVERT] Snitz (MsAccess) to phpBB

Posted: Fri Mar 06, 2015 4:31 pm
by MarcB
Unfortunately, I never got any feedback. Perhaps it is not possible.